www.spacelabshealthcare.com
8-2
XPREZZON
AND QUBE
O
PERATIONS MANUAL
R ECORDING/PRINTING
Under high-load conditions, the following factors are taken into consideration when
a print request occurs:
• Are either of the printers outputting, holding in memory queue, or loading in
queue a print job from this monitor?
• Are either of the printers idle?
• Is this a high priority request (alarm vs. manual)?
• Are either of the printers currently printing a continuous recording?
• Are either of the printer’s queues full?
• Which of the printers is the preferred size for this request (2 or 4 channels)?
Configuration 2
One printer is designated as the primary and the other printer is designated as the
backup. All recordings are sent to the primary printer, unless it is unable to print for
one or more of the following reasons:
• Off-line
• Out of paper
• Disconnected from network
•Powered OFF
• Print queues are full
• Unable to accept recording type
If the primary printer is unable to print, the recordings are then sent to the backup
printer, unless it is also unable to print for a reason listed above.
Configuration 3
Only one printer is available because the network is configured so that recordings
from a given monitor are directed to only one printer on the network. During times
when multiple beds produce alarms, the selection rules will not be applicable, and
print performance is affected.
To Next Page
Loading...
Need help?
General
