www.spacelabshealthcare.com
3-10
XPREZZON
AND QUBE
O
PERATIONS MANUAL
QUBE
™ MONITOR
The Docking Station lets the qube monitor change from a bedside monitor to a
transport monitor quickly and simply.
To prepare the qube for transport, press the release button on the front of the
Docking Station. No disconnection of cables is required.
If your monitor is configured for wireless operation, the transition from docked
(wired network) to undocked (wireless) is seamless. Network functions such as
Alarm Watch, Remote View, and ICS data collection are unaffected (as long as the
wireless signal is adequate).
If your monitor is not configured for wireless operation, network functions such as
Alarm Watch, Remote View, and ICS data collection will not be available while the
monitor is undocked.
To prepare the qube for bedside monitoring, set the monitor down into its docking
station. No disconnection of cables is required.
When you transition the qube from undocked (wireless) to docked (wired network),
there will be a few minutes delay before network functions are active again. Local
monitoring and local alarms are unaffected during the transition period.
Figure 3-4 qube monitor in docking station
To dock the qube monitor
Note:
Disconnect any cables or connectors from the rear of the monitor before placing
on the docking station. A Capnography Pod can be connected when docking the
qube monitor.
1 Lift the qube monitor by its handle and set it down into the docking station.
The release button clicks and illuminates when the monitor is connected.
To Next Page
Loading...
Need help?
General
