Spacelabs qube - To Set Print Duration; To Change the Number of Channels for a Printer Module; To Set the Print Destination for Alarm Recordings; To Set the Print Destination for Non-Alarm Recordings

www.spacelabshealthcare.com
12-10
XPREZZON
AND QUBE
O
PERATIONS MANUAL
M ONITOR SETUP
Figure 12-6 Printer tab
To set print duration
1 Touch Monitor Setup.
2 Touch the Printer tab.
3 Under Duration (seconds), touch either 12 or 20.
To change the number of channels for a printer module
Note:
These options are only available with local printers.
1 Touch Monitor Setup.
2 Touch the Printer tab.
3 Under Number of Channels, touch 1, 2, or 4.
To set the print destination for alarm recordings
1 Touch Monitor Setup.
2 Touch the Printer tab.
3 In the Location box, under Alarm Recordings, touch either Local,
Network, or Both.
To set the print destination for non-alarm recordings
1 Touch Monitor Setup.
2 Touch the Printer tab.
3 In the Location box, under Other Recordings, touch either Local
or Network.