Oxygen Analyzer
3–40 4900002239 rev. G 7-11-17
• Time: Set the current time in hour (h), minute (m) and seconds (s).
• Date: Set the current date in day (d), month (m) and year (y).
• LED Intensity: Adjusts the signal strength of the probe.
If power supply is disabled to the analyzer, Time and Date
settings will be set to zero. Reset Time and Date before starting a
new measurement so that the correct time is stored with the data.
The OXY5500 uses 24-hour time settings.
The LED Intensity setting range is from -5 to 5, with 5 as the
highest probe intensity and -5 the lowest probe intensity. The
default value is 0.
Figure 3–43 Device settings screen
To Next Page
Loading...