Instruction Manual
for
AS380 Series Elevator Integrated Drive Controller
142
Call service floor, project 2's Down Call service floor. Its setting method is same with (4)
the group service floor specification setting.
(12) When group partition each elevator partition set: Usually this specification doesn't need
setting, but if a group of partition functions exist, it has to carry out this setting. Click
button in under [Re. group X/Y] in the frame of elevator in the interface to change middle
line's color within button, it will change the elevator's partition, red color means to divide
to the X set, having no color means to divide to the Y set. After that button is set, click [Re.
group] button underneath the interface.
(13) Whether continued to run specification setting or not when urgent power supply is on:
Usually this specification doesn't need to be set, but if have urgent power supply run
function, have to carry on this setting. Click button underneath [OEPS] of elevator's frame
in the interface, to change the color of middle line of button, the red mean this set elevator
continues to run, having no color means stop running. After setting that button, click
[OEPS] button underneath the interface.
To Next Page
Loading...
Need help?
General
