Storz DUOLITH SD1 - Set-up and operation

1-6
17 361 02 1119
General safety information
The separate operating manuals for all devices used in conjunction with the
DUOLITH
®
SD1 (localisation systems, ECG devices, etc.) must be viewed as part of
the complete operating manual. Always comply with all the information contained
therein.
The system must only be connected to properly earthed and correctly installed
shockproof sockets!
Set-up and operation
There are ventilation slits on the side of the device which must not be covered by
other objects.
• Check that the system is in perfect working order before each use. Read about this in
Chapter 4.6.3 funCtiOnal CheCks and
Chapter 4.7.3 funCtiOnal CheCks.
• Never cover the device when in use!
• Make absolutely sure that no liquid can seep into the system housing or
handpiece.
Storage and transport
Incorrect storage and transport can result in damage to the device and device failure.
• Completely empty the water circuit and the handpiece of the F-SW module before
you transport the device or put it into storage.
Otherwise, there is a risk of the water freezing which will lead to damage. Please
contact your responsible service centre if this does happen.
• Comply with the ambient conditions specied in Chapter 8.1 teChniCal data.
• Make sure that no cables are crushed or sheared.
Disposal
• Comply with national disposal regulations when disposing of the DUOLITH
®
SD1 or
individual components.
• Comply with the relevant information in the operating manuals for the additional
devices.