Storz DUOLITH SD1 - Software Updates

4-27
17 364 02 0320
Operation
4.5.16 Software updates
NOTE
If you have saved the specic presettings for your ultrasound probe in the
system, note them down before the software update and then reenter them
once again after the update.
• Connect the USB stick to the left slot (USB-A, see Chapter 3.1 COntrOl and funCtiO-
nal eleMents) of the Control Device.
• Connect the handpiece to the Control Device.
• Switch on the Control Device - the update starts automatically.
– On the display of the handpiece xxxxx is shown while the update will be perfor-
med.
– On the display of the handpiece the values of the energy are blinking if the
update is nished.
• Conrm the energy values.
h Now you can go on with treatment.