Stratasys Objet260 - Page 192

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-59
23.Inthenextwizardscreen,confirmthatyouhaveremovedalltoolsand
objectsfromtheprinter.
Figure6-84Cleared-trayconfirmationscreen
24.Closetheprintercover.
Thewizardcontinuesbyheatingtheheads,thenfillingandpurgingthem.
Iftherearenoinstallationproblems,theoptimizationprocedurebegins,
tocalibratetheprintheadstothebestworkingconfiguration—
"Optimizing(Calibrating)PrintHeads"onpage6-42.
Ifinstallationproblemsaredetected,thewizardalertsyouandinstructs
youhowtocontinue(see"InstallationProblems",next).
25.Afterreplacingprintheads,youshouldchecktheheadalignmentbefore
usingtheprintertoproducemodels.Inthefinalwizardscreen:
❒ SelectYesandclickDonetoopentheHeadAlignmentwizard(see
"AligningthePrintHeads"onpage6-39).
❒ SelectNoandclickDonetoaligntheheadsatanothertime.
Figure6-85FinalwizardScreen