Stratasys Objet260 - Page 193

Objet260 User Guide 6 Operating and Maintaining the Objet260 3DPrinter
DOC-37004 Rev.E 6-60
InstallationProblems
Iftheprinterdetectsthatthereisaproblemafteryouinstallprintheads,
relevantwarningscreensappear.
•Iftheprintersoftwaredoesnotdetectthereplacedhead,thefollowing
warningscreenappears.
Figure6-86Incorrect-installationscreen
Ifthishappens:
a. Opentheprintheadcompartment(seeFigure6-75onpage6-55).
b. Re-inserttheprint-headdrivercardintoitssocket(seeFigure6-79on
page6-57).
c. Inthewizardscreen,selectthecheckboxtoconfirmthatyouhave
re-insertedthecard,andclickNext.
•Ifthereplacementheadwasnotfactory-calibrated,thefollowingwarning
screenappears.
Figure6-87Invalid-datawarningscreen
Ifthishappens:
a. Removetheheadandreplaceitwithanotherone(startingwithstep10
onpage6-54).
b. Inthewizardscreen,selectthecheckboxtoconfirmthatyouhave
installedanotherprinthead,andclickNext.
c. ContactyourauthorizedCustomerSupportcenteraboutthe
unformattedhead.