FORTH Diagnostics D-7
D
For example:
D.1.5 probe-scsi
,
probe-scsi-all
The probe-scsi test sends an inquiry command to internal and external SCSI
devices connected to the system’s internal SCSI interface. If a SCSI device is
connected and powered up, the target address, unit number, device type, and
manufacturer name should be displayed.
For example:
ok watch-net-all
/iommu@0,100000000/sbus@0,10001000/ledma@5,8400010/le@5,8c00000
Using AUI Ethernet Interface
Lance register test -- succeeded
Internal loopback test -- succeeded
External loopback test -- Lost Carrier (transceiver cable
problem?) send failed.
Using TP Ethernet Interface
Lance register test -- succeeded
Internal loopback test -- succeeded
External loopback test -- succeeded
Looking for Ethernet packets.
’.’ is a good packet. "X" is a bad packet.
Type any key to stop.
...............................................................
...............................................................
ok
ok probe-scsi
Target 3
Unit 0 Disk SEAGATE ST1480 SUN04245828 Copyright (c) 1991 Seagate All rights reserved.
To Next Page
Loading...
Need help?
General
