Chapter 11 System Board and Component Replacement 11-19
FIGURE 11-18 System Board Cable Connections
8. Loosen the two captive Phillips screws that secure the system board to the rear of
the chassis.
See
FIGURE 11-19.
FIGURE 11-19 System Board Captive Screws
9. Pull the board out of the back of the chassis until it clears the plastic card guide.
See
FIGURE 11-20.
10. Place the board on an antistatic surface.
Speaker/LED
Diskette data connector
connector
SCSI data connector
DC power connector
Speaker/LED cable
SCSI data cable
DC power harness
SCSI backplane
CD-ROM audio
connector
Loosen captive screw
Loosen captive screw
To Next Page
Loading...
