2-10 SPARCstation 5 Service Manual—November 1996
2
watch-tpe Monitors broadcast Ethernet packets
(10BASET—Twisted Pair Ethernet)
on the Ethernet cable(s) connected to
the system.
Connect the system to the
network via the desired
Ethernet port.
See description.
watch-net-all Monitors broadcast Ethernet packets
on all Ethernet interfaces installed in
the system, one at a time.
Connect the system to the
network via the desired
Ethernet port.
When an SBus card
network controller
card is installed.
probe-scsi Returns to the display the SCSI
devices (internal and external) and
their SCSI targets connected to the
built-in SCSI port.
Connect external SCSI devices to
the system and turn on
their power.
To determine if a SCSI
peripheral is talking to
the system.
To determine the SCSI
targets (addresses) of a
SCSI device.
To determine if more
than one SCSI
peripheral is assigned
the same SCSI address.
To determine if the
built-in SCSI controller
is defective.
probe-scsi-all Returns to the display the SCSI
devices and their SCSI targets
connected to all SCSI ports (both the
built-in SCSI port and any additional
SCSI host adapter cards).
Connect external SCSI devices to
the system and turn on
their power.
See probe-scsi.
To determine if a SCSI
host adapter controller
is defective.
power-off Powers off the system. You must have a Sun Type-5
keyboard in order to use this
command.
To power off the system
with a Sun Type-5
keyboard.
Table 2-4 Selected FORTH Diagnostic Tests (Continued)
Type of Test Description Preparation When to Use
To Next Page
Loading...
Need help?
General
