Sun Microsystems SPARCstation 5 Model 110 User Manual

Storage Devices 9-27
9
11. Tighten the two captive Phillips screws that secure the board to the rear
of the chassis.
See Figure 9-23.
Figure 9-23 Rear Panel Captive Screws
12. Reinstall the CD-ROM drive (if necessary).
See Section 9.2.2, “Replacing the CD-ROM Drive.”
13. Detach the wrist strap and replace the cover.
See Chapter 7, “Internal Access.”
14. Reconnect all external cables to the rear panel.
15. Power on the system.
See Section 6.2, “Powering On the System.”
9.6 Diskette Data Cable
9.6.1 Removing the Diskette Data Cable
1. Shut down and power off the system.
See Section 6.1, “Powering Off the System.”
2. Remove the cover and attach a wrist strap.
See Chapter 7, “Internal Access.”
3. Remove the CD-ROM drive (if present).
See Section 9.2.1, “Removing the CD-ROM Drive.”
4. Remove the diskette drive.
See Section 9.3.1, “Removing the Diskette Drive.”
Captive screw
Captive screw

Sun Microsystems SPARCstation 5 Model 110 Specifications

General

Brand	Sun Microsystems
Model	SPARCstation 5 Model 110
Category	Desktop
Language	English