Sun Microsystems SPARCstation 5 Model 110 - FIGURE 11-12 Inserting an S24 Frame Buffer Card

11-12 SPARCstation 5 Model 110 Service Manual • November 1996
3. Holding the replacement S24 card at an angle to the rear panel, insert the tabs on
the card backplate into the corresponding slots on the rear panel.
See
FIGURE 11-12.
4. Carefully align the S24 card connector with the AFX Bus slot on the system board.
Press evenly on the corners of the card to push the connector into the socket.
Caution – Do not force the card. Align the card connector and slot properly or you
may damage the pins on the card.
FIGURE 11-12 Inserting an S24 Frame Buffer Card
5. Push the card retainers forward to clamp down the S24 card.
See
FIGURE 11-13.
Open both
card retainers.