Sun Microsystems SPARCstation 5 Model 110 - Peripherals DC Power Harness; Removing the Peripherals DC Power Harness

Chapter 9 Storage Devices 9-19
8. Detach the wrist strap and replace the cover.
See Chapter 7.
9. Reconnect all external cables to the rear panel.
10. Power on the system.
See Section 6.2 “Powering On the System.”
9.5 Peripherals DC Power Harness
9.5.1 Removing the Peripherals DC Power Harness
1. Shut down and power off the system.
See Section 6.1 “Powering Off the System.”
2. Detach all external cables from the rear panel, including the power cord.
3. Remove the cover and attach a wrist strap.
See Chapter 7.
4. Unplug the DC power, SCSI data, diskette data, speaker/LED, and CD-ROM
audio cables from the system board.
See
FIGURE 9-18. You may need to remove an SBus card to access the audio connector.
See Section 11.1.1 “Removing an SBus Card.”