9-10 SPARCstation 5 Model 110 Service Manual • November 1996
FIGURE 9-8 Removing the CD-ROM Filler Panel
4. Remove the diskette drive filler panel (if present) in the same way as you remove
the CD-ROM filler panel, as shown in
FIGURE 9-8. If the diskette drive is installed,
push the diskette drive toward the center of the chassis to disengage it.
Do not push on the drive’s front bezel. You may need to use a screwdriver for
leverage. Use the screwdriver to push on the drive grommets as shown in
FIGURE 9-9.
Push tabs inward
and pull panel out.
To Next Page
Loading...
