Sun Microsystems SPARCstation 5 Model 110 - Replacing the Power Supply; FIGURE 8-1 Removing the Power Supply

Chapter 8 Major Subassemblies 8-3
FIGURE 8-1 Removing the Power Supply
6. Disconnect the power supply connector from the system board.
See
FIGURE 8-1.
7. Slide the power supply toward the chassis front to free it from the chassis mounts.
See
FIGURE 8-1.
8. Lift the power supply out of the chassis and disconnect the DC power harness
(labeled P1) from the keyed connector on the rear of the power supply.
See
FIGURE 8-2.
8.1.2 Replacing the Power Supply
1. Attach a wrist strap and secure it to the rear panel.
See
FIGURE 8-1.
DC power
connector
Power supply
Captive screws
Power supply
rear view
DC power
harness (P1)
Power supply
connector
(some models
have only one)