Sun Microsystems SPARCstation 5 Model 110 - FIGURE 11-2 Opening the Sbus Card Retainers

Chapter 11 System Board and Component Replacement 11-3
FIGURE 11-2 Opening the SBus Card Retainers
4. Remove the SBus card extractor from the replacement SBus card:
a. Bend one leg of the extractor slightly to the outside until the hook clears the
hole in the SBus card.
See
FIGURE 11-3.
b. Remove the other side of the extractor, which should come out easily without
bending it.
Place the replacement SBus card on an antistatic surface.
Push back both
card retainers.