Chapter 11 System Board and Component Replacement 11-17
FIGURE 11-17 Installing a DSIMM
6. Detach the wrist strap and replace the cover.
See Chapter 7.
7. Power on the system.
See Section 6.2 “Powering On the System.”
8. Watch for the system banner to verify that the new memory is recognized by the
system.
The system banner appears at the top of the screen a few seconds after you power on
the system. Check the amount of memory listed in the system banner to verify that
the new memory is recognized by the system.
Push the DSIMM
firmly into its connector
To Next Page
Loading...
