Chapter 11 System Board and Component Replacement 11-11
FIGURE 11-11 Removing an S24 Frame Buffer Card
7. Continue to lift the extractor while lowering the opposite end of the card to free it
from the back panel.
Place the faulty S24 card on an antistatic surface.
11.2.2 Replacing an S24 Frame Buffer Card
1. Locate the AFX Bus slot on the system board.
See
FIGURE 11-9.
2. Push back the two card retainers on the AFX Bus slot (if necessary).
See
FIGURE 11-12.
Note – Before installing the S24 card, inspect the AFX Bus slot for bent pins. Do not
install the S24 card if a pin in the slot is bent. If necessary, straighten bent pins with
needlenose pliers.
Lift both ends of card
extractor simultaneously
to prevent pin damage.
To Next Page
Loading...
