11-16 SPARCstation 5 Model 110 Service Manual • November 1996
11.3.2 Replacing a DSIMM
1. Carefully remove the new DSIMM from its protective packaging and place it on
an antistatic surface.
2. Choose any available slot and unlock (press down) the ejector levers at both ends
of the connector.
3. Align the DSIMM with the slot.
See
FIGURE 11-16. Hold the DSIMM by its edges and orient it so that the two notches
at the bottom of the DSIMM line up with the two tabs in the DSIMM connector.
Note – Slot J0300 (the one closest to the rear panel) must always contain a DSIMM.
If you combine different capacity DSIMMs in the same system, this slot must contain
the highest-capacity DSIMM.
FIGURE 11-16 Orienting a DSIMM
4. Place your thumbs as shown in FIGURE 11-17 and push the DSIMM firmly into its
connector.
5. To lock the DSIMM in place, lift up both ejector levers.
Align notches with
corresponding
tabs in DSIMM
connector.
To Next Page
Loading...
