Major Subassemblies 8-7
8
8.2.2 Replacing the Speaker/LED Cable
1. Feed the LED cable through the chassis wall opposite the light pipe.
See Figure 8-4. Position the replacement LED cable so that the LED just fits
inside the entrance of the LED light pipe.
2. Press the LED cable between the tabs to secure it in place.
See Figure 8-4.
Figure 8-4 Routing the LED Cable
3. Route the LED cable between the diskette drive bracket and the chassis
wall and secure it beneath the metal cable clips on the chassis floor.
See Figure 8-3.
4. Connect the speaker/LED cable to the speaker connectors.
See Figure 8-7.
Press LED cable between
LED light pipe
tabs to secure it in place.
To Next Page
Loading...
Need help?
General
