Sun Microsystems SPARCstation 5 Model 110 - Page 179

Index-3
power on, fails, 4-2
power supply, 8-1
removal/replacement, 8-1 to 8-5
voltage checkpoints, 4-3
power-off command, 2-10
Power-On Self Test
See POST
precautions, 5-3, 10-1
probe-scsi, 2-10, 4-6
probe-scsi-all, 2-10, 4-6
R
rear panel illustration, 1-3
removal/replacement
CD-ROM audio cable, 9-27 to 9-28
CD-ROM drive, 9-5 to 9-8
DC power harness, 9-19 to 9-25
disk drive, 9-1 to 9-5
diskette data cable, 9-25 to 9-26
diskette drive, 9-8 to 9-13
DSIMM, 11-13 to 11-17
NVRAM, 11-24 to 11-25
power LED, ?? to 8-7
power supply, 8-1 to 8-5
SBus card, 11-1 to 11-8
SCSI backplane, 8-12 to 8-14
SCSI data cable, 9-14 to 9-19
speaker, 8-8 to 8-12
system board, 11-18 to 11-23
system cover, 7-1 to 7-6
tools needed, 5-3
replacement parts list, 12-4
requirements for system
environmental, A-2
input power, A-2
RS232, setting jumpers for, 11-22
RS423, setting jumpers for, 11-22
S
safety requirements, 5-1
SBus card, 11-1
removal/replacement, 11-1 to 11-8
SCSI
SCSI backplane, removal/replacement, 8-12 to
8-14
SCSI connector pinout, B-1
SCSI data cable, removal/replacement, 9-14 to
9-19
SCSI targeting conventions, C-1
selftest-#megs parameter, 2-5, 2-9
serial connector pinout, B-5
serial port jumpers, setting, 11-22
speaker, 8-8
removal/replacement, 8-8 to 8-12
specifications
environmental, A-2
physical, A-1
power, A-2
standard features, 1-1
SunDiag System Exerciser, 2-11
SunMicrophone II, 12-3
symbols, 5-2
system
abnormal response, 6-2
subassembly access, 7-1
system banner, 3-4
system board
damage prevention, 10-1
handling instructions, 10-2
layout, 10-2
power connector pinout, 4-4
removal/replacement, 11-18 to 11-22
replaceable components, 10-3
setting jumpers, 11-22
testing, 4-5
voltage checkpoints, 4-5
system cover
removal, 7-1
replacement, 7-4
system unit
external options, 1-5
interior components, 1-2
interior view, 1-2
internal options, 1-4
rear panel illustration, 1-3
T
test <alias name>, D-3
test <device path>, D-3
test cdrom, 2-9
test disk, 2-9
test disk0, 2-9