x Sun StorEdge 3000 Family Installation, Operation, and Service Manual • May 2004
B.3 Supported Host Platforms and Connection Methods (JBOD Arrays) B–2
B.4 Known Limitations Affecting Sun StorEdge 3510 FC JBOD Arrays B–3
B.5 Using Sun StorEdge 3000 Family Software Monitoring and Management
Tools with JBOD Arrays B–4
B.6 Setting the Loop ID on a Sun StorEdge 3510 FC JBOD Array B–6
B.7 Connecting Sun StorEdge 3510 FC JBOD Arrays B–7
B.8 Enabling Sun StorEdge 3510 FC JBOD Array Support B–11
B.9 Downloading Firmware to Disk Drives in a JBOD B–13
B.10 Resizing LUNs Greater than 1 TByte B–13
B.11 Troubleshooting Sun StorEdge 3510 FC JBOD Arrays B–14
B.12 Converting a JBOD to a RAID array B–19
C. Failed Component Alarm Codes C–1
D. Record of Settings D–1
D.1 View and Edit Logical Drives D–2
D.2 LUN Mappings D–4
D.3 View and Edit SCSI Drives D–5
D.4 View and Edit SCSI Channels D–6
D.5 View and Edit Peripheral Devices D–7
D.6 Save NVRAM to Disk and Restore From Disk D–8
E. Cable Pinouts E–1
E.1 RJ-45 Connector E–1
E.2 DB9 COM port E–2
F. Configuring a Sun Server Running the Solaris Operating Environment F–1
F.1 Setting Up the Serial Port Connection F–1
F.2 Accessing the Firmware Application From a Solaris Host F–2
F.3 Redefining the Baud Rate for the tip Command F–3
F.4 Using the tip Command for Local Access to the Array F–4
To Next Page
Loading...
