Chapter 6 First-Time Configuration 6-7
3. Choose “channel Mode.”
A menu of channel mode options is displayed.
4. Select a channel mode from the displayed list.
A confirmation message is displayed.
5. Choose Yes to confirm.
A confirmation message is displayed:
6. Choose Yes to reset the controller.
Refer to the Sun StorEdge 3000 Family RAID Firmware User’s Guide for more
information about modifying channels.
6.1.4 Choosing Loop or Point-to-Point Fibre Connection
To confirm or change the Fibre connection for the array, perform the following steps:
1. Choose “view and edit Configuration parameters → Host-side SCSI Parameters →
Fibre Connection Option.”
A menu of fibre connection options is displayed.
NOTICE: Change made to this setting will NOT take effect until the
controller is RESET. Prior to resetting the controller, operation
may not proceed normally. Do you want to reset the controller now?
To Next Page
Loading...
