Sun Microsystems StorEdge3000 Series - TABLE 8-2 Silencing the Alarm

Chapter 8 Maintaining Your Array 8-5
2. Depending on whether the cause of the alarm is a failed component or a controller
event and which application you are using, silence the alarm as specified in the
following table.
Note – Pushing the Reset button has no effect on controller event alarms and
muting the beeper has no effect on failed component alarms.
TABLE 8-2 Silencing the Alarm
Cause of Alarm To Silence Alarm
Failed Component
Alarms
Use a paperclip to push the Reset button on the right ear of the array.
Controller Event Alarms In the Firmware Application: From the Main Menu, choose “system Functions
→
Mute beeper.” Refer to the Sun StorEdge 3000 Family RAID Firmware 3.27 User’s
Guide fore more information.
In Sun StorEdge Configuration Service: Refer to “Updating the Configuration”
in the Sun StorEdge Configuration Service 1.3 User’s Guide for information about the
“Mute beeper” command.
In the CLI: Run mute [controller].
Refer to the Sun StorEdge 3000 Family CLI 1.6 User’s Guide for more information.