Sun Microsystems StorEdge3000 Series - TABLE C-1 Failed Component Alarm Codes

C-2 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • May 2004
See “Front Panel LEDs” on page 7-2 for more information about the SES/PLD
firmware mismatch mentioned in
TABLE C-1.
Caution – Be particularly careful to observe and rectify a temperature failure alarm.
If you detect this alarm, shut down the controller and the server as well if it is
actively performing I/O operations to the affected array. Otherwise, system damage
and data loss can occur.
Voltage failure V
...-
Temperature failure T
-
SES/PLD firmware
mismatch
R
.-.
TABLE C-1 Failed Component Alarm Codes (Continued)
Failure Morse Code Letter Morse Code Sound Pattern