8-20 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • May 2004
3. To clear events from the log after you have read them, use your arrow keys to
move down to the last event you want to clear and press Return.
A “Clear Above xx Event Logs?” confirmation message is displayed.
4. Choose Yes to clear the recorded event log entries.
Note – Resetting the controller clears all recorded events. To retain event log entries
after controller resets, you can install and use the Sun StorEdge Configuration
Service program.
8.5 Restoring Your Configuration (NVRAM)
From Disk
If you have saved a configuration file and want to apply that same configuration to
another array (or reapply it to the array that had the configuration originally), you
must be certain that the channels and IDs in the configuration file are correct for the
array where you are restoring the configuration.
The NVRAM configuration file restores all configuration settings (channel settings,
and host IDs) but does not rebuild logical drives. See “Saving Configuration
(NVRAM) to a Disk” on page 6-52 for information about how to save a configuration
file, including advice on saving controller-dependent configuration information
whenever a configuration change is made.
See “Record of Settings” on page D-1 for advice about keeping a written record of
your configuration before saving or restoring configuration files. See “Save NVRAM
to Disk and Restore From Disk” on page D-8 for a convenient place to keep records
whenever you save or restore configuration files.
To Next Page
Loading...
Need help?
General
