F-1
APPENDIX
F
Configuring a Sun Server Running
the Solaris Operating Environment
This appendix provides access information and LUN setup information needed
when you connect a Sun StorEdge 3510 or 3511 FC Array to a Sun server running the
Solaris operating environment. For a list of supported adapters, refer to the release
notes for your array.
This information supplements the configuration steps presented in this manual and
covers the following topics:
■ “Setting Up the Serial Port Connection” on page F-1
■ “Accessing the Firmware Application From a Solaris Host” on page F-2
■ “Redefining the Baud Rate for the tip Command” on page F-3
■ “Using the tip Command for Local Access to the Array” on page F-4
■ “Determining the WWN in the Solaris Operating Environment” on page F-4
F.1 Setting Up the Serial Port Connection
The RAID controller can be configured by means of a Solaris workstation running a
VT100 terminal emulation program, or by a Microsoft Windows terminal emulation
program such as HyperTerminal.
Note – You can also monitor and configure a RAID array over an IP network with
the Sun StorEdge Configuration Service program once you have assigned an IP
address to the array. For details, see “Configuring a COM Port to Connect to a RAID
Array” on page 4-19 and refer to the Sun StorEdge 3000 Family Configuration Service
User’s Guide.
To Next Page
Loading...
Need help?
General
