Contents v
4.2 Fibre Channel Array Connections 4–4
4.2.1 Sun StorEdge 3510 FC Array 4–5
4.2.2 Sun StorEdge 3511 FC Array 4–6
4.3 Connecting the Chassis to AC Power Outlets 4–7
4.4 Connecting the Chassis to DC Power Outlets 4–8
4.5 Powering Up and Checking LEDs 4–10
4.6 Reviewing Channels, Ports, and SFPs 4–11
4.6.1 Drive Port Connectivity in a Dual-Controller Array 4–12
4.6.1.1 Sun StorEdge 3510 FC Arrays 4–12
4.6.1.2 Sun StorEdge 3511 FC Array 4–13
4.6.2 Host Port Connectivity in a Dual-Controller Array 4–13
4.6.2.1 Sun StorEdge 3510 FC Array 4–14
4.6.2.2 Sun StorEdge 3511 FC Array 4–14
4.6.3 Default SFP Placement 4–15
4.6.4 Changing Your SFP Configuration 4–18
4.7 Configuring a COM Port to Connect to a RAID Array 4–19
4.8 Setting an IP Address 4–19
4.9 Setting Up Out-of-Band Management Over Ethernet 4–20
4.10 Cabling to Expansion Units 4–22
4.10.1 Scaling a Sun StorEdge Fibre Channel Array Into a High Capacity
Configuration 4–25
4.11 Setting Loop IDs on Expansion Units 4–26
4.12 Connecting Ports to Hosts 4–28
4.13 Power-On Sequence 4–29
4.14 Power-Off Procedure 4–30
5. Configuration Overview 5–1
5.1 Controller Defaults and Limitations 5–2
5.1.1 Planning for Reliability, Availability, and Serviceability 5–2
To Next Page
Loading...
Need help?
General
