SWDM40 OPERATION & MAINTENANCE MANUAL
The key switch is used to turn on/off the
engine, mainly including three working
positions:（OFF）,（ON）,（START）.
OFF: Key can be inserted or pulled out. The
position can cut off the power of all electrical
systems except the cab lights, and stop the
engine.
ON: The position enables all electrical system
to be connected. When the engine is running
normally, the start switch should always be in
this position. If abnormal, check the electrical
system immediately.
START: The starting position of the engine.
When starting the engine, keep the key in this
position.
“Button 1- Working switch” in the
membrane key panel is not connected:
★Press “Button 8”, handle forward, mast
forward.
★Press “Button 8”, handle backward,
mast backward.
★Press “Button 8”, handle leftward, mast
leftward.
★Press “Button 8”, handle rightward,
mast rightward. When “Button 1- Working
switch” in the membrane key panel is
connected, there is no action.
Warning
★ The starting time should not over
than 10 seconds for protecting the
starting motor.
To Next Page
Loading...