5-49
Chapter 5: Web Based Management Utility
Classmap
Clicking the CLASSMAP tab brings up the QOS CLASSMAP SETTINGS page (Figure 5-36),
which is used to classify the stream of traffic. The parameters for this page are shown in
Table 5-29.
Figure 5-36. QOS Classmap Settings Page
Table 5-29. QOS Classmap Settings Page Parameters
Parameter Description
Classmap ID
This parameter specifies a unique ID for the Classmap. It must be in the range
from 1 to 65535.
Filter ID This parameter specifies the unique Filter ID associated with this Classmap.
Filter Type
This parameter specifies the filter type associated with the Classmap. It can be
set as either MAC filter (1) or IP filter (2).
To Next Page
Loading...
