5-55
Chapter 5: Web Based Management Utility
Clock Settings
Clicking the CLOCK SETTINGS link brings up the CLOCK SETTINGS page (Figure 5-41),
which allows to configure the Time and Date in the switch. The parameters for this page
are shown in Table 5-34.
Stack
The Supermicro Intelligent switch supports stacking of the SSE-G24-TG4 and
SSE-G48-TG4 Supermicro switch units. Switch stacking is created by connecting
switches in a daisy chain. One of the stacked switches is selected as a Master based on
its configurations. The Master switch provides management support for the whole stack.
Other switches in the stack are referred to as slave switches.
NOTE: Make sure all stacked switches are running the same version of firmware.
Figure 5-41. Clock Settings Page
Table 5-34. NTP Settings Page Parameters
Parameter Description
Clock Display This display shows the time and date that the switch current has.
Clock Set
These controls allow you to set or modify the time and date. HH:MM:SS for the
Time, and DD:MM::YYYY for the date.
To Next Page
Loading...
