1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-112
IPv4 AddrConf
Clicking the IPV4 ADDR CONF tab brings up the IPV4 ADDRESS CONFIGURATION page
(Figure 5-91), which allows you to configure the IP address for L3 VLANs. The
parameters for this page are shown in Table 5-73.
Oper State This parameter indicates status of VLAN, and whether it is Up or Down.
Description This parameter specifies interface description string for this VLAN.
Figure 5-91. IPv4 Address Configuration Page
Table 5-73. IPv4 Address Configuration Page Parameters
Parameter Description
Interface VLAN ID This parameter specifies the VLAN interface.
Allocation Protocol
This parameter specifies the protocol which is used to allocate IP address for the
given interface. Options are either Manual, DHCP or RARP.
IP Address This parameter specifies the IP Address of the specified interface.
Subnet Mask This parameter indicates the mask for the specified IP Address.
Address Type
This parameter specifies the type of address, which can be Primary or
Secondary.
Broadcast Address This parameter displays broadcast address for the interface.
Table 5-72. VLAN Interface Basic Settings Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
