1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-188
DVMRP
The DVMRP page allows you to configure the DVMRP protocol using the following
pages:
• Basic Settings
• Interfaces
Basic Settings
Clicking the BASIC SETTINGS tab brings up the DVMRP BASIC SETTINGS page
(Figure 5-162). The parameters for this page are shown in Table 5-139.
Figure 5-162. DVMRP Basic Settings Page
Table 5-139. DVMRP Basic Settings Page Parameters
Parameter Description
DVMRP Status DVMRP can be enabled or disabled in the switch using this field.
Prune Lifetime
(Seconds)
This parameter represents the Prune Life Time Configuration value. The allowed
value ranges between 1 and 7200.The default value is 50.
To Next Page
Loading...
