A-5
Appendix A: Rack Installation
Installing the Inner Rails on the Switch
1. Place one of the inner rails on one side of the switch aligning the hook on the side of
the switch with the mounting hole in the rail. Make sure the inner rail faces outward,
as illustrated below.
2. Slide the inner rail forward so that the rail fits securely into the hook on the side of
the switch.
3. Secure the inner rail to the switch with one screw as illustrated below.
4. Repeat steps 1-2 for the remaining inner rail.
Installing the Outer Rails
Use the procedure, Figure A-3 and Figure A-4 below to assemble and install the outer
rails on the rack.
Installing the Outer Rails on the Rack
1. Attach the shorter outer rail to the outside of the longer outer rail. You must align the
pins with the slides. Also, both bracket ends must face the same direction.
2. Adjust both the shorter and longer brackets to the proper length so that the rail fits
snugly into the rack.
3. Secure the long bracket to the front side of the rack with two M5 screws and the
short bracket to the rear side of the rack with three M5 screws.
Figure A-2. Installing the Inner Rail
To Next Page
Loading...
