5-139
Chapter 5: Web Based Management Utility
Virtual Interface
Clicking the VIRTUAL INTERFACE tab brings up the OSPF VIRTUAL INTERFACE
C
ONFIGURATION page (Figure 5-117). The parameters for this page are shown in
Table 5-98.
Figure 5-117. OSPF Virtual Interface Configuration Page
Table 5-98. OSPF Virtual Interface Configuration Page Parameters
Parameter Description
Transit Area ID This parameter specifies the transit area that the virtual link traverses.
Neighbor Router ID This parameter specifies the router ID of the virtual neighbor.
Authentication Type
This parameter allows you to choose MD5, Simple Password or None as the
authentication type.
MD5 Key ID
This parameter specifies the secret key used to create the message digest
appended to the OSPF packet if the authentication type is MD5.
Authentication Key
This parameter specifies the key required for authentication, if authentication is
enabled on this interface.
Hello Interval
This parameter indicates the length of time, in seconds, between the Hello
packets that the router sends on the interface. The allowed value ranges
between 1 and 65535. The default value is 10.
Route Dead Interval
This parameter specifies the number of seconds for which the router waits for
hello packet from the neighbor before declaring this neighbor down. The allowed
value ranges between 0 and 2147483647. The default value is 60.
To Next Page
Loading...
