1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-150
BGP
The BGP link allows you to configure the BGP protocol. Following are the configuration
parameters available to manage BGP through this interface:
• Basics
• Neighbors
• Multi-Exit Disc
• Local Pref
• Filters
• Route Aggr
• Advanced
• Community
Aggregation Effect
This parameter specifies the Aggreation option as one of the following:
• Advertise – When set to advertise and the associated Area ID is 0.0.0.0,
then aggregated Type-5 are generated. Otherwise if associated Area ID is
x.x.x.x (other than 0.0.0.0), then aggregated Type-7 is generated in NSSA
x.x.x.x for the specified range.
• Do Not Advertise – When set to doNotAdvertise (2) and the associated
Area ID is 0.0.0.0, then Type-5 is not generated for the specified range,
while aggregated Type-7 are generated in all attached NSSA. While
associated Area ID is x.x.x.x (other than 0.0.0.0), then Type-7 are not
generated in NSSA x.x.x.x for the specified range.
• Allow All – When set to allowAll and associated Area ID is 0.0.0.0, then
aggregated Type-5 are generated for the specified range. In addition
aggregated Type-7 are generated in all attached NSSA, for the specified
range.
• Deny All – When set to denyAll neither Type-5 nor Type-7 will be generated
for the specified range.
Translation This parameter enables or disables the translation.
Advertise This parameter displays the aggregation status of OSPF V3.
Table 5-106. OSPF AS External Aggregation Configuration Page Parameters
Parameter Description
To Next Page
Loading...
