1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-162
RIP
Clicking the RIP tab brings up the RRD RIP CONFIGURATION page (Figure 5-136), which
allows you to re-distribute the routes that are learnt through other routing protocols to
RIP. The parameters for this page are shown in Table 5-117.
Figure 5-136. RRD RIP Configuration Page
Table 5-117. RRD RIP Configuration Page Parameters
Parameter Description
RIP Status This parameter enables or disables redistribution for RIP.
Default Metric
This parameter specifies the metric for the routes that are being re-distributed.
The default value is 3.
Import
You can use this parameter to choose to import Direct routes, Static routes,
OSPF routes and BGP routes to RIP.
Route Tag Type
This parameter describes whether a tag is manually configured or automatically
generated.
Route Tag
This parameter indicates the route tag in case you configure a manual option for
the tag type. The possible values are between 0 to 65535. The default value is 0.
To Next Page
Loading...
