1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-184
Interfaces
Clicking the INTERFACES tab brings up the PIM INTERFACE CONFIGURATION page
(Figure 5-158). The parameters for this page are shown in Table 5-135.
Figure 5-158. PIM Interface Configuration Page
Table 5-135. PIM Interface Configuration Page Parameters
Parameter Description
Interface This parameter specifies the interface index.
Address Type Specifies the address type, which can be IPV4 or IPV6.
Component ID
This parameter specifies a number uniquely identifying the component. The
allowed range is 1 to 255. The default value is 1.
DR Priority
This parameter specifies the designated Router (DR) priority value for the PIM
component. The DR priority value can be any number from 1 to 65535.The
default value is 1.
Hello Hold Time
(Seconds)
This parameter specifies the time interval between two successive Hello
messages being sent by PIM on this interface.
LAN Delay
This parameter configures LAN delay time for PIM messages. The allowed range
is 0 to 65535. The default value is 0 seconds.
Override Interval
This parameter configures override interval for PIM messages. The allowed
range is 0 to 65535. The default value is 0 seconds.
Query Interval
This parameter configures the time interval between two successive queries
being sent by PIM on this interface. The allowed range is 1 to 255. The default
value is 30 seconds.
To Next Page
Loading...
