5-145
Chapter 5: Web Based Management Utility
Basic Settings
Clicking the BASIC SETTINGS tab brings up the OSPFV3 BASIC SETTINGS page
(Figure 5-122). The parameters for this page are shown in Table 5-103.
Figure 5-122. OSPFv3 Basic Settings Page
Table 5-103. OSPFv3 Basic Settings Page Parameters
Parameter Description
OSPFv3 Status This parameter enables or disables OSPFv3 administratively.
Router ID This parameter uniquely identifies the router in the Autonomous System.
Autonomous System
Border Router Status
This parameter specifies the router as Autonomous System border router.
Area Border Router This parameter specifies the router as an area border router.
External LSDB Limit
This parameter specifies maximum number of non-default AS-external-LSAs
entries that can be stored in the link-state database.
Exit Overflow Interval
This parameter specifies the time interval in seconds a router will attempt to
leave Overflow State. The allowed value ranges between 1 and 65535.
Demand Extension This parameter indicates the router's support for demand routing.
Reference Bandwidth
This parameter specifies Reference bandwidth in kilobits/seconds for calculating
default interface metrics.The allowed value ranges between 1 and 65535.
SPF Delay
This parameter indicates the delay in routing calculation after a topology change.
The allowed value ranges between 1 and 65535.The default value is 5.
To Next Page
Loading...
