5-155
Chapter 5: Web Based Management Utility
Filters
Clicking the FILTERS tab brings up the BGP FILTER CONFIGURATION page (Figure 5-130),
which is used to set the filters on the routes being learnt. The parameters for this page
are shown in Table 5-111.
IP Address Prefix
Length
This parameter is used to calculate the subnet. The allowed value ranges
between 0 and 32.
Intermediate AS This parameter represents the intermediate AS between the BGP peers.
Direction
This parameter can be set for the incoming or the outgoing packets using In and
Out values.
Value
This parameter specifies the Local preference value to be associated with this
learnt path. The allowed value ranges between 0 and 2147483647.
Preference This parameter is used to enable/disable filtering.
Status This parameter specifies the status of the entry.
Figure 5-130. BGP Filter Configuration Page
Table 5-110. BGP Local Preference Configuration Page Parameters (Continued)
Parameter Description
To Next Page
Loading...
