1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-22
SSH
Clicking the SSH (Secure Shell) tab brings up the SSH CONFIGURATION page
(Figure 5-13), which allows you to configure SSH version and keys. The parameters for
this page are shown in Table 5-8.
Port List (Incoming)
This lists the port through which the manager can access this switch. Ports can
be comma separated or provided as a range (for example Gi0/1 or Ex0/1). The
factory default is blank.
VLANs Allowed
This parameter specifies the VLANs through which the manager can access this
switch. VLANs can be comma separated or provided as range (for example 1,2,3
or 1-3 or 1,2-3).
Services Allowed
These control buttons are used to indicate the service type, and can be one or
more of the following: T
ELNET, SSH, HTTP, HTTPS, SNMP or ALL.
Figure 5-13. SSH Configuration
Table 5-8. SSH Configuration Page Parameters
Parameter Description
SSH Version
The default for this parameter is v2. You can choose to configure this as
compatible with v1 instead.
Table 5-7. IP Authorized Manager Page Parameters
Parameter Description
To Next Page
Loading...
