5-109
Chapter 5: Web Based Management Utility
Loop Protect
Clicking the LOOP PROTECT link brings up the LOOP PROTECTION page (Figure 5-88),
which allows you to set the filter configuration to control the multicast packets that the
switch needs to process. The parameters for this page are shown in Table 5-71.
Figure 5-88. Loop Protection Page
Table 5-71. Loop Protection Page Parameters
Parameter Description
Loop Protection This parameter allows you to ENABLE and DISABLE Loop Protection.
Transmit Interval
This parameter allows you to set the time interval in seconds. You can choose
the interval between 1 to 10 seconds. The default value is 5 seconds.
Disable Period
This Parameter allows you to set the disable period in seconds. If this value is
zero, the ports will be kept in the disabled state until the user enables the port by
disabling, enabling loop protection on that port. The supported values are from 0
to 604800 seconds.
Receive Action This parameter allows you to SEND DISABLE or NO DISABLE a received action.
Ports List
This parameter allows you to specify the ports list, for example gi0/1-10, gi0/15,
gi0/20.
To Next Page
Loading...
