1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-182
PIM
The PIM link allows you to perform PIM related configuration through the following
pages:
• Basic Settings
• Component
• Interfaces
• Candidate RPs
• Threshold
• Static RP
Basic Settings
Clicking the BASIC SETTINGS tab brings up the PIM BASIC SETTINGS page (Figure 5-156),
which specifies the PIM status in the switch. The parameters for this page are shown in
Table 5-133.
Figure 5-156. PIM Basic Settings Page
Table 5-133. PIM Basic Settings Page Parameters
Parameter Description
PIM Status This parameter allows you to enable or disable the PIM status in the switch.
PIM V6 Status This parameter allows you to enable or disable the PIM V6 status in the switch.
To Next Page
Loading...
