5-69
Chapter 5: Web Based Management Utility
Storm Control/Rate Limiting
Clicking the STORM CONTROL/RATE LIMITING tab brings up the STORM CONTROL/RATE
L
IMITING page (Figure 5-53), which allows you to configure specific parameters of the
port. You can choose between Auto-negotiation and No-negotiation for a port. If
No-negotiation is chosen, then the speed of the link, FlowControl and duplex modes can
be configured. The parameters for this page are shown in Table 5-42.
Figure 5-53. Storm Control/Rate Limiting Page
Table 5-42. Storm Control/Rate Limiting Page Parameters
Parameter Description
Port This parameter displays the port number.
Mode This parameter allows you to select either Auto Negotiation or No-negotiation.
Duplex This parameter allows you to select either Full Duplex or Half Duplex.
Speed This parameter allows you to select the speed as 10 Mbps, 100 Mbps or 1Gb/s.
Flow Control Admin
Status
This parameter allows you to specify the Flow Control Admin Status as either
Disabled, Trasmit Flow Control Enabled, Receive Flow Control Enabled or both
Transmit and Receive Flow Control Enabled.
Flow Control
Operation Status
This parameter displays the status of the flow control.
HOL Block
Prevention
This parameter allows you to enable or disable Head of Line block prevention.
The following parameters are configurable for Ingress Rate Limiting.
DLF Level
This parameter allows you to specify the destination lookup failure packets per
second.
Broadcast Level This parameter allows you to specify the broadcast packets per second.
To Next Page
Loading...
