1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-96
Port Settings
Clicking the PORT SETTINGS tab brings up the LA PORT SETTINGS page (Figure 5-78),
which configures LA properties at a per-port level. The parameters for this page are
shown in Table 5-61.
Figure 5-78. LA Port Settings Page
Table 5-61. LA Port Settings Page Parameters
Parameter Description
Port This parameter specifies the Interface Index.
Port Channel This parameter specifies the port channel.
Mode This parameter specifies the various port modes, such as On, Active or Passive.
Port Priority
This parameter specifies the priority value of the Port. The allowed values are
from 0 to 65535. The default is 128.
Timeout
This parameter sets the time within which LACP PDUs must be received on a
port to avoid timing out of the Aggregated Link. If a Long timeout is chosen then
the ports will time out of the Port Channel in 90-seconds. If a Short timeout is
chosen then the ports will time out of the Port Channel in 3-seconds.
Wait Time
This parameter configures the waiting time for a port after receiving Partner
information and before entering aggregation. The allowed values are from 0 to
10. The default value is 2.
To Next Page
Loading...
