Suzuki GSX-R1000K5 - Page 138

3-84 ENGINE
OIL PRESSURE REGULATOR
• Apply SUZUKI SUPER GREASE “A” to the O-ring and press
in the oil pressure regulator to the crankcase.
 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)

OIL PAN
• Apply SUZUKI BOND to the mating surface of the oil pan.
99104-31140: SUZUKI BOND “1207B” (USA)
99000-31110: SUZUKI BOND “1215” (Others)
NOTE:
Use of SUZUKI BOND is as follows:
* Make surfaces free from moisture, oil, dust and other foreign
materials.
* Apply to distorted surfaces as it forms a comparatively thick
film.
• Install the oil pan.
NOTE:
Fit the new gasket washers to the oil pan bolts A.

• Tighten the oil pan bolts diagonally to the specified torque.
 Oil pan bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
OIL PRESSURE SWITCH
• Apply SUZUKI BOND to the thread part of oil pressure switch
and tighten oil pressure switch to the specified torque.
99104-31140: SUZUKI BOND “1207B” (USA)
99000-31140: SUZUKI BOND “1207B” (Others)
 Oil pressure switch: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
NOTE:
Be careful not to apply SUZUKI BOND to the hole of thread end.
Use a new O-ring to prevent oil leakage.
Use a new gasket washer to prevent oil leakage.
SAMPLE