4-96 FI SYSTEM DIAGNOSIS
ECT SENSOR INSPECTION
The engine coolant temperature sensor is installed at the cylin-
der head. (4-48)
ECT SENSOR REMOVAL AND INSTALLATION
• Remove the ECT sensor. (7-7)
• Install the ECT sensor in the reverse order of removal.
ECT sensor: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
IAT SENSOR INSPECTION
The intake air temperature sensor is installed on the right side of
the air cleaner box. (4-52)
IAT SENSOR REMOVAL AND INSTALLATION
• Lift and support the fuel tank. (5-3)
• Remove the IAT sensor from the air cleaner box.
• Install the IAT sensor in the reverse order of removal.
IAT sensor: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
AP SENSOR INSPECTION
The AP sensor is located under the front seat. (4-56)
AP SENSOR REMOVAL AND INSTALLATION
• Remove the AP sensor from the frame.
• Install the AP sensor in the reverse order of removal.
TO SENSOR INSPECTION
TO SENSOR REMOVAL AND INSTALLATION
The tip-over sensor is located in front of the battery case.
(4-61)
• Lift and support the fuel tank. (5-3)
• Remove the TO sensor from the battery case.
• Install the TO sensor in the reverse order of removal.
NOTE:
When installing the TO sensor, the arrow mark A must be
pointed upward.
SAMPLE
To Next Page
Loading...
