CHASSIS 8-85
• In this condition, check the “rim line” B cast on the tire side
walls. The line must be equidistant from the wheel rim all
around. If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly seated. If
this is the case, deflate the tire completely and unseat the
bead for both sides. Coat the bead with lubricant and fit the
tire again.
• When the bead has been fitted properly, adjust the pressure
to specification.
• As necessary, adjust the tire balance.
Cold inflation tire pressure
BALANCER WEIGHT INSTALLATION
• When installing the balancer weights to the wheel, set the two
balancer weights A on both sides of wheel rim.
Do not run with a repaired tire at a high speed.
Front Rear
Solo riding
250 kPa
(2.50 kgf/cm², 36 psi)
290 kPa
(2.90 kgf/cm², 42 psi)
Dual riding
250 kPa
(2.50 kgf/cm², 36 psi)
290 kPa
(2.90 kgf/cm², 42 psi)
Weight difference between the two balancer weights
must be less than 10 g (0.02 lb).
SAMPLE
To Next Page
Loading...
